74
CARRIER INSTALLATION WITHOUT THE BASE
WITH THE LAP BELT
Make sure vehicle is on level ground.
Place child in the carrier, refer to Securing Your
Child in the Infant Carrier section, p. 40-43.
Position the infant carrier on a rear vehicle seat,
with the handle in Position 2 ( see pg. 26), with
the foot end towards the vehicle seat back,
push it rmly against the vehicle seat.
Route the lap belt portion of the vehicle belt
into the belt guides on the carrier. Make sure
the vehicle belt is correctly routed on both sides
and the belt is not twisted. Fasten the buckle.
Push infant carrier rmly back and down
towards the vehicle seat as you tension the belt
by pulling on the free end of the lap belt strap.
If necessary, tuck the loose end of the lap belt
out of the way.
Check the recline angle. Adjust the seat angle
until the red level line on the infant carrier is
level with the ground. A tightly rolled towel or
pool noodle may be placed under the infant
carrier near the vehicle seat back to adjust the
angle. See pg. 78-79.
2
1
2
1
Look for this
label on the
shell
To Next Page
Loading...
