70
CARRIER INSTALLATION WITHOUT THE BASE
WITH THE LAP/SHOULDER BELT
NEVER install this child restraint using a non-locking
vehicle lap shoulder belt. ( See page p.50-51) A locking clip
must be used with a vehicle belt that DOES NOT LOCK.
Call Summer Infant Customer Service at
1-401-671-6551 to obtain a locking clip.
Make sure vehicle is on level ground.
Place child in the carrier, refer to Securing Your Child in the
Infant Carrier section, p. 40-43.
Position the infant carrier on a rear vehicle seat, with
the handle in Position 2 ( see pg. 26), with the foot end
towards the vehicle seat back, push it rmly against the
vehicle seat.
Route the lap belt portion of the vehicle belt into the belt
guides on the carrier. Make sure the vehicle belt is correctly
routed on both sides and the belt is not twisted.
NEVER route the shoulder belt through the vehicle belt
guides on sides of seat.
Fasten the buckle.
1
2
1
2
To Next Page
Loading...