71
CARRIER INSTALLATION WITHOUT THE BASE
WITH THE LAP/SHOULDER BELT
Refer to your vehicle Owner’s Manual for
how your vehicle lap and shoulder belt
locks.
In many vehicles, you can switch the
shoulder belt retractor into locking mode
by pulling the shoulder belt out all the way
and then let it go back in. You will hear a
clicking sound. CHECK to make sure its
locked by pulling on it.
To check if the vehicle belt is locked, pull
out on the shoulder belt. The belt should
remain tight if the vehicle system is
locked.
Push infant carrier rmly back and down
towards the vehicle seat as you tension
the belt by pulling on the shoulder belt
portion then feed excess belt into the
retractor.
3
3
To Next Page
Loading...
