72
CARRIER INSTALLATION WITHOUT THE BASE
WITH THE LAP/SHOULDER BELT
Check the recline angle. Adjust the seat
angle until the red line on the infant carrier is
level with the ground. A tightly rolled towel or
pool noodle may be placed under the infant
carrier near the vehicle seat back to adjust
the angle. See page p.78-79.
The carrier is allowed to touch the vehicle
seat(s) in front of it, as long the recline angle
of the car seat is not affected.
Grab the infant carrier at the belt guides and
pull from side to side and front to back to
make sure it is installed correctly. The Infant
Carrier should not move more than 1 inch
(2.5 cm) in any direction.
If the infant carrier moves too much, tighten
the vehicle belts more and re-check. You
may need to try a different vehicle seat
location or installation method, or both.
Push buttons on side of handle to adjust
handle to either Position 1 or 2. Either
position may be used in vehicle, see p. 26.
5
4
6
6
5
4
6
Look for this
label on the
shell
To Next Page
Loading...
