Summer Prodigy - Carrier Installation; Carrier Installation with Vehicle Belt

2OUTETHEVEHICLE
BELTTHROUGHTHE"ELT
'UIDESONBOTHSIDES
OFTHE#ARRIERANDTHEN
BUCKLETHESEATBELT
6ERIFYTHATTHESEATBELT
ISNOTTWISTED
For vehicle seat belt
systems with a
shoulder portion,
you must ONLY
route the lap
portion through the
Belt Guides.
4IGHTENTHE
INSTALLATIONBYPUSHING
THE#ARRIERFIRMLYINTO
THEVEHICLESEATWHILE
PULLINGTHESEATBELT
TIGHT
4
Carrier Installation
Carrier
Installation
with Vehicle
Belt
0LACETHE#ARRIER
REARFACINGONTHE
VEHICLESEAT
-AKESURETHEhLEVEL
TOGROUNDLINEvONTHE
#ARRIERISLEVELTOTHE
GROUND
1
2
3
Carrier Installation
57
56
LINE MUST BE LEVEL
WITH GROUND
WHEN
CARRIER IS
IN
S
T
ALLED
IN
V
E
H
I
C
L
E
W
I
THOUT
THE BAS
E
.
21120–L04
LINE MUST BE LEVEL WITH GROUND WHEN
CARRIER IS INSTALLED IN VEHICLE WITHOUT THE BASE.
NOTE: If needed,
a pool noodle or
a tightly rolled
towel may be
used under the
front of the
Carrier to
correctly adjust
the angle of the
Carrier.
LINE MUST BE LEVEL
WITH GROUND
WHEN
CARRIER IS
I
N
S
TALLED
I
N
V
EH
I
C
L
E
W
I
THOUT
THE BAS
E
.
21120–L04
LOCK YOUR
VEHICLE SEAT
BELT!
REFER TO pages 22 of
this User Guide and to
your vehicle owner’s
manual for more
information regarding
locking your vehicle
belt.
If you have an ELR (Emergency Locking
Retractor) with a sliding latch plate, a
LOCKING CLIP must be used. Please refer
to page 59 of this User Guide for more
detailed installation instructions.
3HOWN3WITCHABLE2ETRACTOR