www.sunhydraulics.com ©2017 Sun Hydraulics Corporation 3
XMD User Manual
HINTS & TIPS
ALWAYS do the following:
• Read ALL product information/data sheets before starting
• Observe the set-up procedures in the product manual for best operational results
• Ensure that you are aware of the consequences of all adjustments on the electronics and hydraulics
before you change settings
• Make sure you have the correct tools to do the intended job (compatible smartphone or tablet with
latest version of the XMD Mobile app installed)
• Ensure that any recommended fuses and/or safety devices are tted as required
• Keep high-voltage AC cables separate from low-voltage DC signal and supply cables
• Make sure the unit’s supply voltage is within required specications
• Check that the unit’s supply voltage is correct, electrically clean and stable
• Isolate this unit from all other equipment before any form of welding takes place
• Check ALL wire connections to and from this unit to ensure NO short or open circuits are present
• Operate the units within specied temperature range for the best, most reliable performance
• Ensure that any unused wires/connections are terminated safely and not shorted together
• Isolate the Amplier if any battery charging or battery boosting takes place on the installation
• Ensure all valve connectors are wired correctly, secured and connected to correct coils
• Follow and abide by all applicable health and safety standards - protect yourself and others
• Attempt to use this unit if you are unsure of electrical or hydraulic connections or expected operation
• Operate this unit without the recommended power supply input fuse installed as recommended
• Arc weld or charge batteries with this driver unit connected as damage can occur
• Attempt to use this unit in areas where other AC or DC coils have not been fully suppressed
• Install Ampliers in vicinity of AC products - e.g., VFD Ampliers, motor starters, HV fuses, etc.
• Use a power supply that is not rated for the correct required output current under full load
• Allow wires to or from the unit to short circuit (to each other or chassis/cabinet)
• Attempt to use this unit in areas of intense Radio Frequency (RF) without adequate screening mea-
sures
• Disconnect or connect wires to or from this unit unless it is isolated from the power supply
• Use this unit in temperatures that exceed specications as operation may be aected
• Start this unit without ensuring ALL work areas are clear of personnel
• Connect +5V reference to Supply Power or Ground as damage will occur
NEVER do the following:
To Next Page
Loading...
