Chapter 3 Setting Up the Sun Fire X4450 Server 33
■ Manages the inventory of hot-pluggable system components
Refer to the Sun Integrated Lights Out Manager Users Guide for detailed information.
Connecting to the LOM Service
Processor for the First Time
This section describes how to connect to the ELOM or ILOM service processor (SP)
for initial setup and configuration. It also includes an overview on SP interfaces and
connections.
Initial LOM Setup Overview
The following process allows a user to connect to the LOM SP for initial setup and
configuration. Instructions are included for both ELOM and ILOM as required.
Use the following procedures to establish a serial connection to the LOM service
processor and configure the LOM SPIP address for the first time.
■ “Connecting to the LOM Service Processor for the First Time” on page 33
■ “Method 1: Access the BIOS” on page 34
■ “Method 2: Connect to the SP Using a Serial Connection” on page 35
■ “Determining the LOM Service Processor IP Address” on page 34
■ “Method 2: Using the Serial Connection” on page 38
■ “Method 3: Using the Service Processor (SP) LOM Web Browser Interface” on
page 40
About Service Processor Interfaces
After you configure the IP address to comply with your network IP scheme, you can
access the LOM SP web browser interface using a Sun Microsystems supported
Internet web browser. You can also connect to the LOM service processor through
secure shell (SSH).
Choose from one of several LOM SP interfaces to support system management on
your server. After you have determined the IP address of the SP, you can access SP
firmware applications through the following LOM SP interfaces:
■ Serial Port CLI
■ Secure shell (SSH) CLI
To Next Page
