Chapter 4 Configuring the Preinstalled Solaris 10 Operating System 45
Installation Worksheet
Fill in TABLE 4-1 with information you need to configure the preinstalled Solaris 10
OS for the server. Collect only the information that applies to your system.
TABLE 4-1 Installation Worksheet
Installation Information Description Enter System Configuration:
Asterisk (*) indicates default.
Language Choose from the list of available languages
for the Solaris 10 software.
English*
Locale Choose your geographic region from the list
of available locales.
English
(C - 7-bit ASCII)*
Terminal Choose the type of terminal that you are
using from the list of available terminal
types.
Network connection Is the system connected to a network? Networked
Non-networked*
DHCP Can the system use Dynamic Host
Configuration Protocol (DHCP) to configure
its network interfaces?
Yes
No*
If you are not
using DHCP,
note the network
address.
IP address If you are not using DHCP, supply the IP
address for the system.
Example: 129.200.9.1
Subnet If you are not using DHCP, is the system
part of a subnet?
If yes, what is the netmask of the subnet?
Example: 255.255.0.0
255.255.0.0 *
IPv6 Do you want to enable IPv6 on this
machine?
Yes
No*
Host name A host name that you choose for the system.
Kerberos Do you want to configure Kerberos security
on this machine?
If yes, gather the following information:
Default Realm:
Administration Server:
First KDC:
(Optional) Additional KDCs:
Yes
No*
To Next Page
