30 SPARC Enterprise Mx000 Servers Administration Guide • August 2009
■ To Create a VACM Group
■ To Create a VACM View
■ To Give a VACM Group Access to a VACM View
■ To Display VACM Information for the SNMP Agent
■ To Configure the SNMP Agent to Send Version 3 Traps to Hosts
■ To Enable the SNMP Agent
■ To Display SNMP Agent Configuration
■ To Enable or Disable the Service Processor HTTPS Service
■ To Enable or Disable the Service Processor Telnet Service
■ To Configure the Service Processor SMTP Service
■ To Enable or Disable the Service Processor SSH Service
■ To Generate a Host Public Key for SSH Service
Note – You can use the setupplatform(8) command rather than the following
procedures to perform network installation tasks. For more information, see the
setupplatform(8) man page.
▼ To Configure the DSCP Network
1. Log in to the XSCF console with platadm or fieldeng privileges.
2. Type the setdscp command.
You can use one of two methods, as follows:
■ Use the setdscp command with the -y -i address -m netmask options:
For example:
XSCF> setdscp -y -i address -m netmask
XSCF> setdscp -y -i 10.1.1.0 -m 255.255.255.0
To Next Page
Loading...
