Sun Microsystems Sun SPARC Enterprise M5000 - To Display System Board Status; To Access a Domain from the XSCF Console; To Attach a CD-RW;DVD-RW Drive or Tape Drive While the Solaris os Is Running on a High-End Server

68 SPARC Enterprise Mx000 Servers Administration Guide • August 2009
3. Verify the domain is powered on by opening a console to it, with the console
command.
See “To Access a Domain From the XSCF Console” on page 68.
▼ To Display System Board Status
1. Log in to the XSCF console with platadm, platop,orfieldeng privileges or
domainadm, domainmgr,ordomainop privileges for a specific domain.
2. Type the showboards command:
▼ To Access a Domain From the XSCF Console
1. Log in to the XSCF console with platadm, platop,oruseradm privileges or
domainadm, domainmgr,ordomainop privileges for a specific domain.
2. Type the console command:
where domain_id is the domain you want to access. This command supports both
interactive and read-only connections; the default is a read-write connection.
3. To return to the XSCF console, press the Enter key, then the escape character,
then type “.”. By default, the escape character is “#”.
▼ To Attach a CD-RW/DVD-RW Drive or Tape
Drive While the Solaris OS Is Running on a
High-End Server
1. If the volume management daemon (vold) is running, stop the daemon:
2. Log in to the XSCF console with platadm privileges.
XSCF> showboards -a
XSCF> console -d domain_id
% #.
XSCF>
# /etc/init.d/volmgt stop