Note: Two values of IR ON and OFF need to keep 30 of the gap to
avoid the problem of IR LED blinking repeatedly.
7.Troubleshooting
3.PARK TIME
The waiting time (or idle time) before the camera executes its PARK
ACTION (see below). The default is 15 seconds.
4.FRAME SPEED
The rate the dome scans continuously between two preset points. Valid
value 1~31. Please read the “The Full Preset List” to learn how to set left
and right scan boundary.
6. IR ON SENS
The value of photoresister to turn on the IR LED, default is 210.
7. IR OFF SENS
The value of photoresister to turn off the IR LED, default is 185.The
difference betwen the LED ON and LED OFF values must be at least 30
to aviod problems of IR LED blinking. Only half side of IR will be on for
nearview, please zoom in to enable the further view and the other side
of the IR.PRESET 130+CALL to manually turn on both sides together.
For AHD camera users, unless an AHD+DVR combo is purchased, please
rst check your DVR compatibility before reading the form below.Incom-
-patible DVR can cause problems such as B/W display, blurry image, no
video or lack of PTZ function. Feel free to contact Sunba to double check.
8. CAMERA
This menu is for engineer’s development purpose and is not open to
end-users.
9. RESET
Restore the camera to default.
5.LED MODE
A. AUTO MODE: Turn on and off IR LED automatically according to the
value of photoresister. If the value of the ambient environment (CURRENT
LEVEL) is ≥ the IR ON SENS, then the LED will be turned on automatically,
vice versa. Larger CURRENT LEVEL is equivalent to darker environment.
B. MANUAL mode: Open and close the IR LED manually. This can be
accomplished using The Special Presets (see the preset list above).
- 12 -
To Next Page
Loading...
