Sunbeam Oskar Professional LC7600C - Operating the Food Processor; Safety Notes and Overload Protection

10
Important: Iftheprocessingbowlandcover
arenotcorrectlyassembled,theOskar™
Professionalwillnotfunction.
Using your Oskar™ Professional
1.Plugthepowercordintoa230-240VAC
poweroutletandturnthepower‘ON’.
2.UsingtheOn/Offbuttononthecontrol
panel,pressoncetostartprocessing.
ThePulsefunctionremainsonaslongasthe
Pulsebuttonispresseddown.
Furtheringredientscanalsobeaddedwhile
processingbypouringthroughthefeedtube
oncethefoodpusherhasbeenremoved.
3.Afteryouhavecompletedprocessing,press
theOn/Offbuttontostopprocessing.
Note: Formaximumcontrolwhenusingyour
foodprocessor,beforeturningonyourfood
processorloadthefeedtube.Alwaysusethe
foodpusherformoreevenlyprocessedfoods
andneveruseyourfingers.
Important: TheOskar™Professionalisfitted
withasafetythermalcut-outdeviceand
willshutoffintheeventofoverload.Ifthis
occurs,switchtheapplianceoffanditwill
automaticallyresetwhencool.
Using your Sunbeam Oskar™ Professional continued
11
Note: Allattachmentsmustbefirmly
attachedtothespindle.Alwaysadjustthe
attachmentsuntilyouaresurethattheyare
correctlyfitted.
Placing the spindle
1.Fitthespindleontothedriveshaft,
seefigure4.
Universal ‘s’ blade
1.Fittheprocessingbowlandspindleas
detailedpreviouslyinfigures1,2&4.
2.Removetheuniversal's'bladefromthe
storagedrawer.
3.Fittheuniversal‘s’bladeoverthespindle
andpressfirmlyintoplace,seefigure5.
Warning: Usecaution,asbladesaresharp.
Alwayshandletheuniversal‘s’bladebyits
centralplasticsection.
4.Placefoodintotheprocessingbowl.
5.Fittheprocessingcovertotheprocessing
bowl,seefigure3andplacethefood
pusherinthefeedtube.
6.Plugthepowercordintoa230-240VAC
poweroutletandturnthepower‘ON’.
7.StartprocessingusingtheOn/OfforPulse
buttons.
8.Whenprocessingiscomplete,removethe
spindleandbladefromtheprocessingbowl
beforeremovingtheprocessedfood.
Fitting/using the tools on your
Oskar
™
Professional
Fig 4
Fig 5
Using your Sunbeam Oskar
®
Professional continued
Using your Oskar
®
Professional
Note: For maximum control, load the feed tube
before turning on your food processor. Always
use the food pusher formore evenly processed
foods and never use your fingers.
Important: The Oskar
®
Professional is fitted
with a safety thermal cut-out device and
will shut off in the even of overload. If this
occurs, switch the appliance off and it will
automatically reset when cool.
Oskar
®