Sunbeam Oskar Professional LC7600C - Fitting and Using the Tools; Spindle and Universal Blade Installation

11
Note: Allattachmentsmustbefirmly
attachedtothespindle.Alwaysadjustthe
attachmentsuntilyouaresurethattheyare
correctlyfitted.
Placing the spindle
1.Fitthespindleontothedriveshaft,
seefigure4.
Universal ‘s’ blade
1.Fittheprocessingbowlandspindleas
detailedpreviouslyinfigures1,2&4.
2.Removetheuniversal's'bladefromthe
storagedrawer.
3.Fittheuniversal‘s’bladeoverthespindle
andpressfirmlyintoplace,seefigure5.
Warning: Usecaution,asbladesaresharp.
Alwayshandletheuniversal‘s’bladebyits
centralplasticsection.
4.Placefoodintotheprocessingbowl.
5.Fittheprocessingcovertotheprocessing
bowl,seefigure3andplacethefood
pusherinthefeedtube.
6.Plugthepowercordintoa230-240VAC
poweroutletandturnthepower‘ON’.
7.StartprocessingusingtheOn/OfforPulse
buttons.
8.Whenprocessingiscomplete,removethe
spindleandbladefromtheprocessingbowl
beforeremovingtheprocessedfood.
Fitting/using the tools on your
Oskar
™
Professional
Fig 4
Fig 5
Fitting/using the tools on your
Oskar
®
Professional