Sunbeam SDP1500BK - Getting Started with Your Coffee Machine; How to Make Iced Coffee; How to Make Hot Coffee

3
Let’s make Iced Coffee!
1. Start with the unit unplugged.
WARNING: To prevent injury from hot
steam or potential damage to the unit do
not plug the unit in until the water is in
the reservoir and the tumbler is put in
place.
2. Fill the tumbler to the “WATER” marking
with filtered water.
3. Pour water into the reservoir.
NOTE: Do not pour above 475ml max fill
line as water reservoir will overflow.
4. Using the Over Ice side of the coffee
scoop, add 1-2 scoops of coffee grounds
to the coffee filter. Rotate the shower
head over the coffee filter and grinds.
Close the lid.
NOTE: Ensure grounds do not spill into
water reservoir when filling coffee filter.
Removing coffee filter to fill with grounds
can help prevent accidental spills into the
reservoir.
5. Fill the tumbler with large ice cubes to
the “ICE” marking.
6. Place the tumbler under the brew spout
and plug unit in. Press the OVER ICE
button – ensure the LED is illuminated.
7. While your coffee is brewing, prepare your
frothed milk if you wish.
8. Wait 3-4 minutes for brewing to
complete, then add your favourite coffee
mix-ins.
9. Insert straw in lid, place lid on tumbler
and enjoy!
Let’s make Hot Coffee!
1. Start with the unit unplugged.
WARNING: To prevent injury from hot steam
or potential damage to the unit do not plug
the unit in until the water is in the reservoir
and the tumbler is put in place in.
2. Grab desired coffee cup or mug and fill with
as much water as you would like coffee.
TIP: Taller coffee mugs work best to avoid
any splashing during brewing.
3. Fill the reservoir with the desired amount
of water, according to the marks on the
inside of the reservoir.
NOTE: Do not pour above 475ml max fill
line as water reservoir will overflow.
4. Using the HOT side of the coffee scoop,
measure coffee grounds that correspond
to amount of water poured.
NOTE: If you prefer bolder hot coffee, you
can use an extra ½ - 1 scoops of coffee
grounds.
5. Pour coffee grounds into reusable coffee
filter.
NOTE: Ensure grounds do not spill into water
reservoir when filling coffee filter. Removing
coffee filter to fill with grounds can help
prevent accidental spills into the reservoir.
6. Rotate the shower head over the coffee
filter and grinds. Close the lid.
7. Place the mug that was used to measure
water under the Brew Spout. Press HOT
BREW button.
8. Wait 3-4 minutes for brewing to
complete, then add in your favourite
coffee mix-ins. Enjoy!
Let's get you started