SunComm SC-1695i - General Feature Codes for System Setting; Static IP Configuration

User Manual
_______________________________________________________________________________
SunComm Technologies Co., Ltd.
7
3.2 General Feature Codes for System Setting
Table 3-3-1 Feature codes for system setting
Dial numbers Features
*114# Pla
y
the
p
hone NO.
*115# Check the TT number of
g
atewa
y
(
usin
g
j
ust when the device interconnects
*150*a# Set IP address
(
static/DHCP
),
a can be di
g
it 1 or 2
,
*150*1# is static IP
*152*a*b*c*d Confi
g
ure IP address
,
a
,
b
,
c
,
d are the four fields of IP address.
*153*a*b*c*d Confi
g
ure subnet mask. a
,
b
,
c
,
d are the four fields of the subnet mask
*156*a*b*c*d Confi
g
ure the device
g
atewa
y,
a
,
b
,
c
,
d are the four fields of the device
*158# Re
p
ort the IP address
*157 Settin
g
the work mode
(
route or brid
g
e
),
* 157 * 0 # is route mode
,
* 157 *
*195# Pla
y
record
*198# Clear record
*199# Settin
g
Record. dial*199# start record
(
≤ 20s
),
then
p
ress # end the
*111# Restart device
3.3 Static IP Configuration
This chapter introduces IP configuration of SC-1695ithrough calling IVR.
Assuming the IP address of a SC-1695i device is 192.168.1 200, subnet mask is 255.255.255.0, IP
of gateway is 192.168.1.1, configured as follows:
1) Please make sure hardware installation have finished
2) Dial the phone number of the SIM card. Dail "*150*1#" after hearing "please dail extension
number ". Hang up after hearing "setting successful"
3) Dial the phone number of the SIM card. Dail "* 152 * 192 * 168 * 1 * 200 #"after hearing
"please dail extension number ". Hang up after hearing "setting successful"