CHAPTER 10
CLEANING YOUR
PRO SERIES SYSTEM
APPLICATOR CLEANING
Cleaning is a necessary part of your regular care of your spray unit. The unit’s applicator
and cup should be cleaned after each days use to maintain consistency in performance
and the long life of the parts. Please follow these instructions carefully
1. Remove the air hose from the applicator.
2. With the applicator placed over the sink, carefully unfasten the solution cup.
3. Pour excess solution back in to the bottle.
4. Fill your empty applicator cup with warm water (NOT hot) and attach your
applicator unit back onto your turbine hose.
5. On the handle of your applicator, wind the adjusting wheel all the way to number
‘12’ in order to open the spray orice fully.
6. Spray the water solution for about 20 seconds through the applicator. This
process will dissolve any build up of residue which can hinder spray
performance.
7. Empty excess water from applicator cup into the sink.
8. Repeat steps 4 to 7 if necessary.
9. Remember to return wheel back to its original position after nal rinse.
10. Use a towel to lay the cup and applicator on and allow to air dry overnight.
DO NOT turn applicator upside down and pour water into the applicator
DO NOT submerse the applicator in water
DO NOT remove the pick up tube
DO NOT poke or push anything into the front nozzle
22
To Next Page
Loading...