CHAPTER 11
TROUBLE SHOOTING and
RECOMMENDATIONS
PRO SYSTEM AND PRO APPLICATOR
TROUBLE SHOOTING
“My turbine will not turn on”
• Power cord not plugged in - Make sure plug is pushed in tight to the base of the turbine
and the poer plug is in the power socket
• Electricity not turned on - Make sure power point turned on
• On/Off switch on Off position - Turn on switch to on position
“My spray applicator is leaking”
• Cup not tight enough – tighten cup with correct procedure
• Too much solution – pour a small amount back into solution bottle
• Foreign matter caught in nozzle – clean with correct procedure
• Solution Pick Up Tube is facing the wrong way – ensure tube is facing toward the front of the
applicator (toward nozzle piece)
“My spray applicator is intermittent”
• Insufcient solution in cup – add solution to the cup
• Applicator angled too steeply during application – alter spray technique
• Cup not tight enough – tighten cup with correct procedure
• Foreign matter caught in nozzle – clean with correct procedure
• Solution Pick Up Tube is facing the wrong way – ensure tube is facing toward the front of the
applicator (toward nozzle piece)
• Air Vent is blocked – Make sure vent underneath turbine unit is clean
“My Spray applicator is not spraying at all”
• Spray applicator wheel set too low – increase number on applicator wheel
• Foreign matter caught in nozzle – clean with correct procedure
• Insufcient solution in cup – add solution to the cup
• Trigger Sticking – Fill cup with warm water, set applicator dial to 12 turn system on and rmly
‘ick’ trigger approx. 20 times to loosen
• Solution Pick Up Tube is facing the wrong way – ensure tube is facing toward the front of the
applicator (toward nozzle piece)
“My Applicator is continually spraying”
Foreign matter caught in nozzle – clean with correct procedure
Trigger Sticking – Fill cup with warm water, set applicator dial to 12 turn system on and rmly
‘ick’ trigger approx. 20 times to loosen
“There is not enough air pressure coming though my Applicator”
• Hose not connected properly - Ensure hose is locked in position properly
• Air Vent is blocked – Make sure vent underneath turbine unit is clean
24
To Next Page
Loading...