CHAPTER 1
SYSTEM SET UP
A QUICK SET UP GUIDE FOR YOUR SUNFX PRO TANNING SYSTEM
SUNFX PRO PROFESSIONAL TANNING SYSTEM
PRO SERIES TOWER
The SunFX Pro Professional turbine produces a constant supply of air to be applied through
the hand held spray applicator. Air is taken in at the base of the unit then through the hose and
directed to the applicator.
Please ensure the turbine unit is on a at working surface or oor, this will prevent the vent
being covered which may cause overheating and damage to the turbine motor. We also
recommend that the turbine be placed as far away from the spray area as possible to limit
any spray being sucked in by the vent.
There are three indentations in the top part of the unit. These are used to hold the spray applicator
when not in use. At the base of the unit there is an intake for the hose and a place to plug in the
power cord.
WARNING: If the electrical cord is damaged, it must be replaced by a cord set recommended by
the manufacturer or its service agent. Please contact SunFX for further advice in this situation.
1
To Next Page
Loading...