17
WARM UP TIME &
USAGE GUIDELINES
Our saunas are based on the infrared wavelength and not cabin temperature. Set to the
desired temperature and allow the sauna to warm up for 45-60 minutes. The sauna heats up
at an average of 1 degree per minute . Follow these steps for proper warm up:
Step 1: Make sure your sauna is plugged into a dedicated circuit installed by your electrician.
Step 2: Set to the desired temperature and set time to 60 minutes.
Step 3: When turning sauna on for the rst time, ensure each heater is active after a
couple of minutes. If they are not, make sure connections are securely paired from their
initial wire feed coming from the power box under the bench.
Step 4: Never fully cover the oor grate and heater with any obstruction that will not
allow the heater to dissipate its heat.
NOTE: If your sauna is outside in an unheated garage, sun room, basement or patio, you
may require additional time to warm the sauna up depending upon the temperature of
the surrounding surface & room. REMEMBER, you are required to have an authorized
Sunlighten cover over your sauna if it is outside or exposed to the weather in order to
maintain your warranty.
TIPS FOR OPTIMAL USE
• Sauna requires a dedicated circuit and outlet for optimal performance. This
should be installed by a certied electrician before assembling.
• Use Sunlighten All Natural Cleaning Kit for periodic cleaning.
• If you have a floor heater, clean every 6 months for residential use, and every month for
commercial use. To clean, remove floor grate and vacuum out heater area.