Sunnen LBB-1660 - Safety Instructions

IMPORTANT NOTE
The temperature requirements of Sunnen
®
Honing Machines, equipped with electronic components, have been established
as 35 degrees C (95 degrees F). Above this temperature, an optional cooler will be available to handle temperatures from
35º to 46º C (95º to 115º F). IT IS NOT recommended that Machine, equipped with electronic components, be operated at
temperatures above 46º C (115º F). Sunnen Products Company warrants Machine, equipped with electronic components, for
operating environments up to 35ºC (95º F). For operating environments of 35º to 46º C (95º to 115º F) the warranty only
applies if the optional cooler is installed on Machine, equipped with electronic components. No warranty coverage is offered
for operating environments above 46º C (115º F).
iv
1
DO NOT touch electrical components until main input power has been turned off and CHARGE lamps are extinguished.
WARNING: The capacitors are still charged and can be quite dangerous, after power has been turned off.
SAFETY INSTRUCTIONS
READ FIRST
This machine, like any equipment, may be dangerous if used improperly. Please read all warnings
and instructions before attempting to use this machine.
Always disconnect power at main enclosure before servicing machine.
1
Always wear eye protection when operating this machine.
WARNING: Do not wear cotton or heavy gloves while operating this equipment! If gloves must be
worn, wear only the tear-away type
NEVER open or remove any machine cover or protective guard with power "ON." Always disconnect
power at main enclosure before servicing this equipment.
1
DO NOT attempt any repair or maintenance procedure beyond those described in this book.
Contact your Sunnen
®
Field Service Engineer or Technical Services Representative for repairs not
covered in these instructions.
Due to the wide variety of machine configurations, all possibilities cannot be described in these
instructions. Instructions for safe use and maintenance of optional equipment ordered through
Sunnen, will be provided through separate documentation and/or training provided by your Sunnen
Field Service Engineer or Technical Services Representative.
DO NOT attempt to defeat any safety device on this machine or on any of the optional equipment.
If specially built automation components are added to this system, be sure that safety is not
compromised. If necessary, obtain special enlarged work area safety system from Sunnen Products
Co.