To move the bike, grab the Handlebar (No. 5) securely then push downwards until the
back end of the bike comes off of the ground. Once the two front wheels located on the
front stabilizer hit the ground and are put into motion, you can safely and easily move
the bike to the desired location.
Use the wrench to unscrew the nut under the saddle to adjust it to the desired angle.
Once the angle is located, re-install and secure the nut. Check the nut periodically to
ensure that it is secure, use the Spanner (No. 33) to tighten when needed.
To Previous Page
Loading...
