sunsation SUN 3000 - Motor Wiring: Standard CMO; Motor Wiring: Sunea RTS CMO & Simu

Sunsation Instructions Manual
Pantone 1375 C
RGB: 255, 158, 27
CMYK: 0, 38, 89, 0
HEX: #FF9E1B
Gray 49%
16
Toggle
Switch
Motor
Junction box
Drip loop
White - Neutral
Black - Hot
Green - Ground
White - Neutral
Black to Brown - (White) Push-button
Red - (Yellow) Push-button
Green - Ground
Motor
Junction box
Line in
Drip loop
Line in
Toggle
Switch
Motor
Junction box
Drip loop
White - Neutral
Black - Hot
Green - Ground
White - Neutral
Black to Brown - (White) Push-button
Red - (Yellow) Push-button
Green - Ground
Motor
Junction box
Line in
Drip loop
Line in
Standard CMO motor wiring
Warning: Do not wire two
or more LT operators to
one single pole switch. This
will cause the motors to
malfunction.
Sunea motors comes with an 18" exterior fast connector.
If you would like to hard wire, you'll need to cut o the
connector.
Note: RTS motors can be wired in parallel.
The motor must be
installed with a drip loop
to prevent water from
entering the motor.
Note: While Somfy motors are designed for outdoor usage, they are NOT
waterproof. An awning with a motor requires a hood to protect the motor
from water damage. Awnings without a hood, WILL NOT be eligible for
warranty repair or replacement.
Sunea RTS CMO and Simu motors wiring
It's recommended to have a dedicated powerline for the motor, and should stay powered on.
Shutting the motor could cause programing wipeout and other defects.