10
11
FIGURE 9
Place the bottom of the arm over the
deck plate that you installed. Secure
the arm to the deck plate by lifting the
ground bracket handle and rotating
it clock-wise approximately 1/4 turn
until it locks.
FIGURE 11
Extend both arms to the desired
height.
WARNING: DO NOT LEAVE THE
AWNING UNATTENDED IN THIS
POSITION. YOU MUST LOWER
ONE ARM OR BOTH TO CREATE
ENOUGH DROP (FRONT TO BACK) AND
PREVENT RAIN FROM
ACCUMULATING ON THE FABRIC.
FAILURE TO DO SO MAY RESULT IN
THE COLLAPSE OF
THE STRUCTURE, WHICH COULD
CAUSE PERSONAL INJURY.
FIGURE 10
Release the handle and make sure it is
locked in the 'down' position. Test
to be sure that the arm is secured to
the deck plate.
FIGURE 6
Extend the RIGHT arm until the front
roller reaches head height.
FIGURE 5
Push both rafters 'UP' until they lock.
FIGURE 7
Unlatch the LEFT arm from the wall
bracket. Swing the arm away from the
house, half way out, set it on the floor
and secure with your foot. Lower
that arm all the way down.
FIGURE 8
Swing the arm to the fully vertical
position.
FIGURE 3
Using the hand crank, unroll the
awning until the fabric is fully
extended.
Rotate
Lift
FIGURE 4
Adjust the roller bar position until the
arrow on the Roller Bar aligns with
the OPEN arrow on the side of the
Drive Unit.
OPEN Arrow
Roller Bar
Arrow
Drive Unit
To Next Page
Loading...
Need help?
General
