5
Note: Make sure that the dark Gray Bushing is sll on the pin end of the Roller Cap.
Figure 10
Note: The Fabric should roll over the top of the Roller Bar, from the right side,
while facing the Gear Assembly.
WARNING: THE FOLLOWING PROCEDURE SHOULD BE ACCOMPLISHED BY FOUR (4) PEOPLE.
Figure 11
Figure 10
Gear Assembly End
Figure 11: Underside View
Inside Bolt
Front Bar Connector
Lateral Arm
Lateral Arm
Front Bar Front Bar
Note: If you have unrolled the Awning past the point where the Lateral Arms are fully open, the Fabric will
begin to sag. To correct this, simply reverse the rotaon of the Hand Crank and close the Awning unl the
Fabric is ght.
To Next Page
Loading...
