TROUBLESHOOTING
Burner will not ignite when using the igniter:
Cylinder valve is not on Turn cylinder valve on (page 10)
Cylinder is empty Replace with a full cylinder (page 10)
Igniter is not sparking Remove plate and visually check ignition box for a spark.
If there is no s
ent.
Igniter button is not working Contact authorized service agent
Injector is blocked
Clean injector with a toothbrush. Do not drill out or use
wire. Do not remove injector. Contact authorized service
agent
Burner flame is erratic:
Burner is blocked Remove burner and check for obstruction
Flame is burning inside
burner (hissing sound)
Turn off burner, allow to cool and re-ignite (page 2)
Regulator is faulty Contact authorized service agent
Injector is partially blocked
Clean injector with a toothbrush. Do no drill out or use
wire. Do not remove
injector. Contact authorized
service agent.
Gas is leaking from connections:
Connections are loose Tighten loose connections (do not over-tighten) and leak
test under pressure with soapy water solution (page 7)
Hose has deteriorated Replace hose
Gas valve is faulty Contact an authorized service agent
Threads are damaged Contact an authorized service agent
MAINTENANCE
It is recommended that, at the commencement of each barbecue season the following
maintenance be conducted. This maintenance is required throughout the life of the barbeque
BURNER
1. Inspect the port holes, primary air inlet and mixing throat for any signs of blockage. Clean out
with compressed air or a length of wire if necessary.
2. Wire brush the outside of the burner to remove rust and dirt.
3. Replace the burner.
GAS SUPPLY
1. Inspect the gas supply hose for any deterioration and replace it if necessary.
2. Test the gas circuit for leaks and remedy any found.
TROLLEY
1. Check all fasteners for tightness and re tighten where necessary to ensure rigidity of the
structure.
2. Re coat the timber with a suitable finish.
16
To Previous Page
Loading...