5) Relationship between the Take-up Lever and the Hook
Hook point timing is directly related to thread tension and thread breaks. The following pictures show the
location of hook when the take-up lever starts to move up from the lower dead stop (main shaft rotation angle:
292°).
[CAUTION]
In normal hook timing, the hook should be in the (C) range in the picture below.
Fast Hook Timing
Slow Hook Timing
[Fig.4-26]
too small
too large
[Fig.4-27]
[Fig.4-28]
Groove of the hook is in the (A) range.
The hook point will take up the thread when
the loop is too small. Stitching will be faster
than the take-up movement. As a result, the
thread tension will be too loose, upper thread
loop will be too small, and skipped stitches
will occur.
Groove of the hook is in the (B) range.
The hook point will take up the thread when
the loop is too large, so there may not be
skipped stitches. However, the take-up
movement will be faster than the stitching and
thread breaks may occur.
To Next Page