14
8. Thread stand
1) As in the Figure, fix the thread stand① to table.
9. Knee Lifter Pad
1) As in the figure, attach knee lifter pad① to the lower part
of oil pan. And then fix it with bolt②.
2) Loosen bolt③ to adjust position of knee lifter pad①.
[ Figure 15 ]
10. Adjusting height of Presser Foot
1) Turn pulley to place feed dog in the lower part of needle
plate.
2) When presser foot① is up, make presser foot① down by
lowering presser bar lifting lever②.
3) Adjust the position of presser foot① by using screw③.
①
①
②
②
③
③
[ Figure 14 ]
[ Figure 13 ]
①
To Next Page