13
5. Deflation Bushing cap
1) Remove deflation-bushing cap①.
2) If deflation-bushing cap① is not removed, oil may spill
from gearbox cover②.
6. Machine body
1) Insert two hinges ① firmly into the holes of the rear side
of machine bed.
2) Put machine body on the rubber cushion ③, while
putting hinges ① on the hinge bed rubber ② safe and
sound.
3) Insert the machine body sustaining pole ④ into table
completely. If the pole is not inserted completely, that
may cause accidents because the pole cannot sustain the
weight of machine body firmly, when the body bent
backwards.
7. Program Unit
1) As in the Figure, combine program unit ① to bracket ③
with three screws ②.
2) Attach the combined bracket ③ to the upper part of
machine body with three screws ④.
①
②
③
④
[ Figure 11 ]
①
②
[ Figure 10 ]
[ Figure 12 ]
①
②
④
③
To Next Page
Loading...
