SunStar SWF/B-T1201C - CHAPTER 11 ERROR MESSAGES AND CORRECTIONS; MAIN SHAFT MOTOR ERRORS

108
1. Starting point
2. Assigned number of stitches for offset
3. Number of the stitch where embroidery ends
4. Offset middle point
5. Offset point
The path at the beginning of the embroidery is 4.
The path of the offset point from the assigned
number of stitches for the offset point: 1-3-1. The
path after the embroidery is finished 2-3.
CAUTION
1) The offset middle point and the offset point can be the same.
2) The offset setup is deleted when a different design is called up.
LESSON: Set the offset point as follows:
1. Start Point X:-300 Y:500
2. Middle Offset X:600 Y:1500
3. Offset Point X:800 Y:2000
Press at the beginning
menu.
=== START POINT ===
=> FRAME MOVE
Use the frame transfer key
to setup X:-300, Y:500. Then Press
=== MIDDLE OFFSET ===
=> FRAME MOVE