61
When all the data has been read
from the tape, the following screen
appears. To store the data, move
the cursor to “YES”
And then Press
DO YOU WANT TO SAVE ?
[YES] [NO]
As shown above, the tape format is
automatically detected. The communication
method of GNT4604 and SERIAL is the same
as above.
■ EXTERNAL OUTPUT
OUTPUTS THE DESIGN
LESSON: Use the SERIAL communication to send data to another SWF machine.
1. SERIAL
2. PARALLEL
Call the design you want
“4.EXTERNAL.OUTPUT”
Press the START key of the
machine receiving the data.
The screen below appears and the
data is sent.
EXTERNAL OUTPUT
==> DATA PENDING !
EXTERNAL OUTPUT
==> DATA SENDING !
To Next Page
Loading...
