70
■ X SATIN
This function edits the width of a satin stitch in the X (left to right) direction. This can be increased in
increments of 0.1mm on each side. The default is set for 0 and the range is from 0 to 5.
■ Y SATIN
This function changes the satin span in the Y direction.
LESSON: Edit the # 5 design as follows:
X SCALE : 150% START ST :100
Y SCALE : 120% X SATIN : 3
MIRROR : Y Y SATIN : 2
ANGLE OF ROTATION: 45 degrees
Changing the satin width 2mm on each side.
2mm 2mm
NOTICE
When a new design is read into the memory of the machine, all settings revert to
the default settings.
Select the design in Location #5
1] X_SCALE : 100[%]
2] Y_SCALE : 100[%]
3] ANGLE : 0
4] MIRROR : NO MIRROR
Press
SPEED : 0[RPM]
0/ 1991[00%]
TOTAL : 258051[ST]
NEEDLE : 1[6] 1
To Next Page
Loading...
