SunStar SWF/B-T1201C - Page 87

81
LESSON: Select the design in Location #8 and repeat the design as indicated below:
Repeat X: 5 times Y Design Interval: –40mm
Repeat Y: 5 times X/Y Priority: X Priority
X Design Interval: 40mm Design Interval: JUMP code
Call design
Press
To input how many times X should
be repeated, press the numerical
key #5 and then press
To input how many times Y should
be repeated, press the numerical
key #5 and then press
==== REPEAT SETTING ====
1] X REPEAT
1 -> 99
=> ( 0)
==== REPEAT SETTING ====
2] Y REPEAT
1 -> 99
=> ( 0)
==== REPEAT SETTING ====
3] X Design Interval
-300
-
> +300[mm]
=> ( 0)
SPEED : 0[RPM]
0/ 1991[00%]
TOTAL : 258051[ST]
NEEDLE : 1[6] 1