SunStar SWF/B-T1201C - Page 88

82
To setup the X design interval
input 40 and then press
To select X as priority input “
–
1”
and then press
Before the design interval, press
the UP key once or twice.
For design interval set-up use the
cursor key to make the next screen
appear.
==== REPEAT SETTING ====
4] Y Design Interval
-300
-
> +300[mm]
=> ( 0)
==== REPEAT SETTING ====
4] Y Design Interval
-300
-
> +300[mm]
=> ( -40)
==== REPEAT SETTING ====
5] Y/X Priority
Y(0), X(1)
=> ( Y)
==== REPEAT SETTING ====
6] Design Interval
JUMP(0), STOP(1)
=> ( JUMP)
You can check and change the setup data as
above. The number indicated in “( )” indicates
the number input for setup.
To setup the Y design interval
input “
–
40” and then press