Sunstream FL-24020D - Powerpack Connection and Depressurization; Charging System and Lift Testing

PART NO. 690809 REV: A 21
Attaching/removing the Powerpack
To attach:
 Position the powerpack in the desired position on the dock next to the FloatLift.
 Verify pump circuit breakers are in the ‘off’ position.
 Attach the 8 hoses from the powerpack to the lift by matching the hoses to corresponding backside of the
powerpack. Quick disconnects need to be seated firmly so collars seat.
 Match colored labels for each hose and Powerpack fitting.
 Ensure hoses are protected from chaffing, pinching and kinking.
 If additional hose length is required, contact Sunstream for hose extensions.
 Use caution not to turn elbow fitting on manifold when attaching or disconnecting hoses, since this will
cause the fitting to leak. If elbow is loosened, causing a leak, tighten appropriately to stop leak.
To Remove:
 Depressurize by turning off ‘A’ and ‘B’ breakers, then touch ‘up’ then ‘down’ button briefly.
 If boat is on lift, lift must be in the fully lowered or in the fully raised (over-center) position, since this will
pressurize the quick disconnect hose fittings, making it difficult to connect later.
Depressurizing QD’s:
 Quick disconnects (QD’s) may be depressurized by depressing the nipple of the Quick disconnect.
 Do this inside a bucket to catch fluid release.
 A 3/8” bolt 2” or longer is needed to reach the nipple inside the female QD.
 Use extreme caution not to disrupt the o-ring seal inside the female QD.
Charging System
 Confirm which charging system is used (AC charger or Solar Charging). Confirm 12V and 24V wires are
connected inside Powerpack
 AC Charger: Confirm the voltage is set correctly for the power (120V or 230V).
 AC Charger: Confirm wire has correct plug for local power.
 AC Charger: Connect Charger and turn on Charger power. Confirm proper charging by LED indicator or amp
meter.
Testing FloatLift
 Turn on circuit breakers.
 Lower FloatLift to lowered position by pressing the ‘Dn’ button on the wireless transmitter, or by the ‘Down’
button on the remote control box inside the powerpack.
 Raise the lift without a boat to the full up position by pressing the ‘up’ button on the wireless transmitter, or by
pressing the ‘Up’ button on the RC box.
Installation
Connect (8) Quick-Disconnects between
hoses and Powerpack.
Match color labels between hoses and
Powerpack QDs