Sunstream FL-24020D - Operation; Basic Operating Instructions; Operational Notes and Warnings

PART NO. 690809 REV: A 22
FLOATLIFT BASIC OPERATING INSTRUCTIONS (See sticker inside lid of Powerpack)
 Conduct Daily Use Inspection as specified on adjacent Maintenance Reminders sticker
 Lift can be operated using the up/down buttons on the wireless remotes, or on the buttons on
the RC box.
Verify power is on:
 Pump A: Turn on Circuit Breaker A
 Pump B: Turn on Circuit Breaker B
 RC power: Rocker switch on RC box
To Lower FloatLift:
 Press Down button on Key Fob Transmitter or on RC box (small black box inside Power-
pack).
 The lift can be lowered just low enough to start engines. Boat can be boarded in this position.
 When ready to depart, lower just enough to release boat.
 Raise lift if it will not be used for an extended period of time to keep bunks clean.
To Load boat on FloatLift:
 If FloatLift is raised, lower lift enough to accept boat
 Slowly load boat on lift, and center weight of boat within about 12” of center of lift (fore/aft),
and within 6” of Port/Stbd.
 Press the ‘Up’ button and verify fore/aft balance. Front and rear of floats shall be within 4” in
elevation.
 Stop part way when floats are in best position for unloading boat.
 After unloading, continue ‘Up’ until both port and starboard floats are locked over-center,
with the wheels on the outer downslope of the roller plate ramp
Important:
 If lift takes more than 2 minutes to lift (3 minutes for FL36 & FL40), verify both power units
are operating
 Max capacity 24,000 lbs for FL24, 36,000 lbs for FL36 & 40,000 lbs for FL40
 Max beam 13’ 9”
 Inspect lift per operating manual every use and every 6 months
 If Solar Charging is used, Solar Panels must be in direct sunlight for at least 6 hours a day
 Powerpack must be in safe location on dock
Warnings
 Keep people away from moving unit,
 Keep hands and feet away from wheels and moving parts
 FloatLift should be left in the fully up position
 Connecting a powerpack to a FloatLift in a different lifting position then when disconnected
will cause changes to fluid level, and possible overflowing of fluid.
Operation