Website: www.sunsynk.com E-mail: sales@globaltech-china.com
10
4. INSTALLATION
4.1. Installation Location Environment
The location of the battery should be in accordance with operating temperature range and IP rating
specified in the Specification section of this manual. Although the batteries run at a low temperature,
proper airflow around the batteries is recommended.
When installing the set, the following conditions should be met:
DO NOT install the product in a completely closed area with no air-conditioning, it can overheat and
cause a fire.
DO NOT place in direct sunlight or near a source of heat. This can cause deformation, a breakdown,
or a fire. Pay extra attention when you place the system near windows.
The battery must not be set where excessive oil smoke, steam, moisture or dust is contained in the
air.
Ensure that the batteries are installed in a clean environment with minimal dust.
Avoid installing the set near the ocean. If unavoidable, appropriate air filtration should be used to
prevent salt air in contact with the batteries.
For proper air circulation to dissipate heat, allow a clearance of approximately 30 cm to the sides of
the battery.
DO NOT install the set near heat sources.
Figure 3 – Minimum clearance.
To Next Page
Loading...
Need help?
General
