EasyManuals Logo

SunSynk SSLB1 Installation Manual

SunSynk SSLB1
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #23 background imageLoading...
Page #23 background image
Website: www.sunsynk.com E-mail: sales@globaltech-china.com
23
j) EXCEPT AS OTHERWISE PROVIDED BY APPLICABLE LAW, THE FOREGOING REMEDIES
STATE SUNSYNK LTD’s SOLE AND EXCLUSIVE OBLIGATION AND YOUR SOLE AND
EXCLUSIVE REMEDY FOR A BREACH OF THE FOREGOING LIMITED WARRANTY.
9.6. Product Suitability
Sunsynk Ltd’s products are designed to meet stated EU AND U.S. Safety Standards and Regulations.
Because local safety standards and regulations vary significantly, Sunsynk Ltd cannot guarantee that
products meet all applicable requirements in each locality. Customer assumes responsibility for
compliance with such safety standards and regulations in the localities in which a product will be shipped,
sold or used. Before purchase and use of any product, Customer shall review the product application,
and national and local codes and regulations, and must verify that the use and installation of the product
will be in compliance therewith.
9.7. Warranty Term
a) The warranty period (‘Warranty Period’) for the Covered Product commences upon the initial purchase
from Sunsynk Ltd or from an Authorised Dealer (as evidences by the purchase invoice date).
b) The Warranty Period for the Product Warranty (Section 3) terminates upon the earlier of (i) 123 months
after purchase of the Covered Product, or (ii) 120 months after installation of the Covered Product by
an Authorised Dealer.
c) The Warranty Period for the Performance Warranty (Section 4) terminates upon the earlier of (i) 123
months after purchase of the Covered Product, or (ii) 120 months after installation of the Covered
Product by an Authorised Dealer, or (iii) 10,000 full (100%) charging cycles of the Battery Pack.
9.8. Persons Entitled to Make Warranty Claims
Warranty claims may only be made by the original purchaser of a Covered Product, if the Covered
Product has been registered through Sunsynk Ltd’s product registration website during the installation
process by the Authorised Dealer, or a person to whom the title to the Covered Product has been
transferred, provided that the Covered Product remains in its original location and configuration
(including, without limitation, a purchaser of a building, who acquires the covered product as a fixture to
the building).
9.1. Claim Notice
a) If you believe that you have a justified claim covered by this Factory Warranty, you must submit the
claim in writing (‘Claim Notice’) to Sunsynk Ltd within the applicable Warranty Period to Sunsynk
Ltd’s address set forth above, or such future address as Sunsynk Ltd may provide from time to time.
Any Claim Notice must include the following information:
the serial number of the Covered Product for which a Claim Notice is being sent;
a copy of the dated purchase receipt for the Covered Product;
a copy of the installation protocol for the Covered Protocol signed by an Authorised Dealer;

Other manuals for SunSynk SSLB1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the SunSynk SSLB1 and is the answer not in the manual?

SunSynk SSLB1 Specifications

General IconGeneral
BrandSunSynk
ModelSSLB1
CategoryCamera Accessories
LanguageEnglish

Related product manuals