SRC-93 SERIES User’s Manual
22
To learn infrared codes directly from a device’s remote
control, follow these steps:
Press and hold the SETUP button on
the Touch Screen.
Press each number button (2, 4, 6, 8)
until it disappears.
Use the arrow buttons on the Touch
Screen to select LRN and then press
the OK button.
1. Use the device keys to select the
device you want to program.
Make sure the other remote control is
pointed directly at the SRC-93
SERIES’s Learning eye. Keep them 2~4
inches apart. (5~10 cm)
Rubber Keys
The first screen shown represents the
rubber buttons (Rubber Keys) on the
bottom half of the SRC-93 SERIES. You
can program each button using this
screen.
2. Use the Touch screen to select
which key you want to program – it
should now be flashing.
The DEVICE key’s
code will be sent
when you press the
device button on the
SRC-93 SERIES. (For
example when you
press TV, VCR,, etc....)
To Next Page
Loading...
