SRC-93 SERIES User’s Manual
42
Beep Toggling
This setting specifies whether you want the SRC-93
SERIES to beep each time a button is pressed.
Use the BEEP selection in the SETUP Menu to change
this setting:
1. Use the OK button to toggle the
beep from ON to OFF.
Resetting to Factory Defaults
This setting will erase all user specified settings (ex.
PWDN, LITE…) and reset the SRC-93 SERIES back to
factory defaults.
Also the learning codes, Q CH will be erased.
To reset the SRC-93 SERIES, use the RST selection in the
DELETE Menu:
1. Press the number keys (2, 4, 6, 8)
to confirm RESET selection.
2. Press OK to reset the SRC-93
SERIES.
To Next Page
Loading...
