Sunway SSWC-06-1224-TA

Questions and Answers

H
heatherfloresAug 1, 2025
What to do if Sunway SSWC-06-1224-TA is not charging?
- A
  adam85Aug 1, 2025
  If your Sunway Control Unit isn't charging, it could be due to a couple of reasons. First, check if the voltage from the Wind turbine and photovoltaic panels is too low; observe and wait until the wind or PV is strong enough. Alternatively, the battery voltage might be too high, causing it to be in an overvoltage condition, which is normal.
T
Tammy AlexanderAug 7, 2025
What to do if Sunway SSWC-06-1224-TA connected to the battery does not output?
- A
  Anna RogersAug 7, 2025
  If your Sunway Control Unit, when connected to the battery, isn't providing any output, it could be due to several reasons. The battery voltage may be below the release point; in this case, it is normal to wait for the system to charge to the recovery point. It is also recommended to remove the photovoltaic panels and observe and test after 1 minute.
B
brendamyersAug 14, 2025
Why is the speed of the wind turbine very low with Sunway SSWC-06-1224-TA Control Unit?
- B
  Brianna PerryAug 14, 2025
  If the wind turbine speed is very low when using the Sunway Control Unit, there are a few potential causes: * The wind speed might be too low; observe and wait for when the wind speed is high enough. * The battery may not be securely connected, causing the controller to initiate open-circuit protection; ensure it is securely connected. * The battery voltage could be too high, putting it in a brake condition; observe after the battery discharges.
A
Anthony WoodAug 19, 2025
How to troubleshoot a Sunway SSWC-06-1224-TA that doesn't work when connected to the battery?
- M
  Megan AndersonAug 19, 2025
  If your Sunway Control Unit isn't working when connected to the battery, it's possible that the battery voltage is too low. In this case, use a charger to charge the battery or replace the battery.
Y
yjonesAug 26, 2025
What to do if Sunway SSWC-06-1224-TA Control Unit still has no output when batteries rose to a recovery point, from over-discharge point?
- W
  William BerryAug 26, 2025
  If your Sunway Control Unit still has no output even after the batteries have reached a recovery point from an over-discharge point, it might be because the controller has a two-minute delayed output. Observe and test again after one minute.