Sunwebcam Solar 4G Camera - Page 29

26
Solar Panel x1
Holder for Angle x1
M6 Cross Screw x2
M6 Pad Washer x4
M6 Spring Washer x2
Square Nut x2
Put the Square Nut into the slot of Solar Panel ( the Square Nuts should be put at the middle of the Solar Panel).
Then put the 'Holder of Angle' on the Solar Panel, aligning with the Square Nuts.
Put the Spring Washer and 2pcs Pad Washer into the M6 Cross Screw, just like the second photo above.