Sunwebcam Solar 4G Camera - 7.3. Pole Mounting

28
Unscrew the screws on the bottom of camera, then lock the Holder for Angle on it.
Step 2. Assemble Bracket on Camera
Align the arc slot of Camera with 4 holes of Bracket. You can adjust the angle before screw. Put Spring Washer and
Pad Washer into M6 Screw, then lock screw.
7.3.Mount the solar panel or camera on the pole
There are two ways to mount the holder on the pole ( use U Ring or stainless Ribbon).
For the Pole diameter
φ
60mm~140mm
，
you can use U Ring, locked by nuts like photo below.