9
LX-100
SPECIFICATIONS
LX-101
LX-101-P
Cable type
Type
PNP output
NPN output
Model No.
LX-101-Z
LX-101-P-Z
Plug-in connector type
Item
Sensing range
Spot size
Supply voltage
Current consumption
Output 1
(OUT)
Protection
Ambient temperature
Ambient humidity
Ambient illuminance
Voltage withstandability
Vibration resistance
Shock resistance
Short-circuit protection
Output operation
Short-circuit protection
Output operation
10
3 mm 0.394 0.118 in
1
5 mm 0.0390.197 in (at 10 mm 0.394 in setting distance)
12 to 24 V DC
10 % Ripple P-P 10 % or less
Response time
Teaching input
Mark mode: 45 !s or less, Color mode: 150 !s or less
Digital display
Sensitivity setting
Fine sensitivity adjustment function
Timer function
Emitting element
Material
Cable
Cable extension
Weight
Accessory
4-digit red LED display
Mark mode: 2-level teaching / Full-auto teaching, Color mode: 1-level teaching
Incorporated
Incorporated with variable ON-delay / OFF-delay timer, switchable either effective or ineffective (Timer period: 1 to 500 ms, 9 levels variable)
IP67 (IEC)
10 to 55 C 14 to 131 F (No dew condensation or icing allowed), Storage: 20 to 70 C 4 to 158 F
35 to 85 % RH, Storage: 35 to 85 % RH
Incandescent light: 3,000
#
x at the light-receiving face
1,000 V AC for one min. between all supply terminals connected together and enclosure
10 to 500 Hz frequency, 3.0 mm 0.118 in double amplitude (max. 20 G) in X, Y and Z directions for two hours each
500 m/s
2
acceleration (50 G approx.) in X, Y and Z directions for three times each
Combined Red / Green / Blue LEDs (Peak emission wave length: 640 nm 0.025 mil / 525 nm 0.021 mil / 470 nm 0.019 mil)
Enclosure: PBT, Display: Polycarbonate, Operation buttons: Silicone rubber, Lens: Glass, Lens holder: Aluminum
Extension up to total 100 m 328.084 ft is possible with 0.3 mm
2
, or more, cable.
M4 (Length 30 mm 1.181 in) screw with washers: 2 pcs.
Incorporated
Mark mode: Light-ON / Dark-ON (Auto-setting on teaching), Color mode: Consistent-ON / Inconsistent-ON (Setting on teaching)
Incorporated
Inverted operation of the output 1
Note: Mating cable is not supplied with the plug-in connector type. Please order it separately.
Environmental resistance
<NPN output type>
NPN open-collector transistor
• Maximum sink current: 50 mA
•
Applied voltage: 30 V DC or less (between output and 0 V)
• Residual voltage: 1.5 V or less (at 50 mA sink current)
<PNP output type>
PNP open-collector transistor
• Maximum source current: 50 mA
•
Applied voltage: 30 V DC or less (between output and V)
•
Residual voltage: 1.5 V or less (at 50 mA source current)
<NPN output type>
NPN open-collector transistor
• Maximum sink current: 50 mA
•
Applied voltage: 30 V DC or less (between output and 0 V)
• Residual voltage: 1.5 V or less (at 50 mA sink current)
<PNP output type>
PNP open-collector transistor
• Maximum source current: 50 mA
•
Applied voltage: 30 V DC or less (between output and V)
• Residual voltage: 1.5 V or less (at 50 mA source current)
<NPN output type>
NPN non-contact input
• Signal condition: High
5 V to V, or open
Low
0 V to
2 V
(source current: 0.5 mA or less)
• Input impedance: 10 kΩ approx.
<NPN output type>
NPN open-collector transistor
• Maximum sink current: 100 mA
•
Applied voltage: 30 V DC or less (between output and 0 V)
• Residual voltage: 1.5 V or less (at 100 mA sink current)
<PNP output type>
PNP open-collector transistor
• Maximum source current: 100 mA
•
Applied voltage: 30 V DC or less (between output and V)
•
Residual voltage: 1.5 V or less (at 100 mA source current)
0.34 mm
2
5-core cabtyre cable, 2 m 6.562 ft long
(Note)
Net weight: 120 g approx., Gross weight: 180 g approx. Net weight: 55 g approx., Gross weight: 120 g approx.
Output 2
(OUT)
<PNP output type>
PNP non-contact input
• Signal condition: High
4 V to V
(sink current: 3 mA or less)
Low
0 V to 0.6 V, or open
• Input impedance: 10 kΩ approx.
Normal mode: 750 mW or less (Current consumption 30 mA or less at 24 V supply voltage)
ECO mode: 600 mW or less (Current consumption 25 mA or less at 24 V supply voltage)
To Next Page
Loading...
