Release 06/2019
10
Spectroquant
®
NOVA 60A - Operating Manual
– To switch on the photometer, open the cover.
The photometer performs a check (Self-Check)
of the entire system and then switches auto-
matically to the concentration measuring mode.
After approx.
5 s:
Commissioning
Self-check of the photometer
Automatic change to the measuring mode,
concentration
Preparing the photometer
The photometer operates at an environmental
temperature of +5 °C to +40 °C. During trans-
port from cold to warm surroundings, conden-
sation can form resulting in the malfunction of
the meter.
Before putting the photometer into service,
wait until it has adapted to the new environ-
mental conditions (see also chapter TECHNICAL
DATA, in the FUNCTIONAL DESCRIPTION docu-
ment [on CD-ROM]).
– Place the photometer on a hard, flat surface
and protect it against intensive light and heat.
Line operation
– Plug the original power pack into the socket
on the photometer
– Plug the power pack into the line socket
– Switch on the photometer (open the cover).
Battery operation
– Charge the battery for approx. 5 hours before
the initial commissioning. To do this:
• Plug the original power pack into the socket
on the photometer
• Plug the power pack into the line socket and
then the battery will be charged.
During battery operation or when the meter is
at a standstill for longer periods of time, the
battery runs down. This can result in your pho-
tometer no longer being ready for operation.
When the following symbol
is displayed, charge the battery:
Switching on the photometer
To Next Page
Loading...