10
ASSEMBLY INSTRUCTIONS
DANGER !
Do not ride with a bike that has not passed 100% safety verification before
each ride as described in the section called PRE-RIDE SAFETY CHECK
A
C D
B
1. HANDLEBAR INSTALLATION
A. Use the 5mm hex wrench to remove the bolts of the handlebar clamp.
B. Once the clamp is open, place the lower crossbar of the handlebar in
the groove of the top crown.
C. Loosely tighten the handlebar clamp with the 5 mm hex wrench, and
adjust the angle of the handlebar to riders comfort.
D. Cross tighten the handlebar clamp from corner to corner making sure
the clamp is evenly placed, tight, and handlebars do not move.
To Next Page
Loading...
