11
2. INSTALL PEDALS
A. Install and tighten the pedals using the 15 mm open wrench. Look for a letter
marking “L” “R” on each respective pedal and make sure you install the left
pedal on the left crank, the right pedal on the right crank. (Tighten with
recommended torque of 29-34 for pedals)
B. The right pedal is screwed on in a clockwise direction. The left pedal is
screwed on by turning it counter-clockwise.
3. (REAR DERAILLEUR AND GEARING)
If you have a European model or have added speeds
on your bike, make sure to check that your chain
and derailleur is properly aligned by looking at the
derailleur from the rear.
The two pulleys should be lined up exactly underneath
one another, so that the chain runs straight up
from the tension pulley to the jockey pulley, with no
sideways slant. Compare the line of the pulleys with
that of the sprockets above them.
4. TIRE INFLATION
For transport purposes, tires are packed partially inflated. Tires must be inflated
using a pump with a Schrader valve tip to a recommended 20-25 psi (1.38-1.72 bar).
E. Inflate the tube to a max pressure of 35 PSI in order to
ensure the tire is properly seated in the rim.
F. Once properly seated, deflate to a recommended 20-25
psi (1.38-1.72 bar). PSI will vary based on the weight of rider
and type of terrain.
TIP
A
B
The inner tube size is 20”x4.5” for the rear and the
front.
To Next Page
Loading...
