SUPER73 ZX - Page 12

12
4. ZX HEADLIGHT INSTALLATION (EUROPE MODELS ONLY)
You will need the following tools:
• 5mm Allen key
• 4mm Allen key
• 10mm hex wrench
• Head light
• Head light bracket
• Bolt & lock nut
!
1. Remove one
screw from the
frame (fork) using a
5mm Allen key
4. Place the headlight
between the two
hooks of the bracket.
Insert the bolt
through both bracket
and headlight.
2. Insert the screw in
the headlight bracket
so that the grooves
are facing upwards.
3. Tighten the screw
with the 5 mm Allen
key. Leave it slightly
loose so that it can
be adjusted later.
5. Place the lock nut
on the other side
of the bolt and use
the 4mm Allen key
to tighten the lock
nut from the other
side with a 10mm hex
wrench
6. Return to the first
screw, adjust the light
so that it is straight.
Tighten it completely
with the 5mm Allen
key
7. Finally, connect
the light cable to the
loose yellow cable
plug on the fork.
Make sure the arrows
on the cables are
facing each other.
Once bike is powered
on, turn on the
lights by pressing
the UP arrow on the
display until the light
illuminates. Follow the
same step to turn off
the lights.
CAUTION:
The small pins in the plug bend easily, take extra care while connecting the cables.