2
Do not expose pump to freezing temperatures. Discharge pipe or hose (not included) should
not be exposed to freezing temperatures as this may cause damage to the pump.
Do not use this pump for potable/drinking water. Use only in applications for which the
pump is designed for.
According to the state of California (Prop 65), this product contains chemicals known to the
state of California to cause cancer and birth defects or other reproductive harm.
DO NOT UNDER ANY CIRCUMSTANCES REMOVE THE GROUND PIN.
The 3-prong plug must be inserted into a mating 3-prong grounded receptacle. If the
installation does not have such a receptacle, it must be changed to the proper type, wired and grounded in
accordance with the National Electrical Code and all applicable local codes and ordinances.
SAFETY INFORMATION (CONTINUED)
All wiring must be performed by a qualified electrician.
Keep hands clear of suction and discharge openings.To prevent injury, never insert fingers
into pump while it is plugged in.
Do not handle this pump with wet hands or while standing on wet or damp surfaces or in
water.
If a flexible discharge hose is used, make sure the pump is secured to prevent movement.
Failure to secure the pump could result in pump malfunction.
This pump motor is equipped with an automatic resetting thermal protector and may restart
unexpectedly.
When a pump is in its application, do not touch the motor, pipes, or water until the unit is
unplugged or electrically disconnected.
The pump should only be used with liquids compatible with pump component materials.
If the pump is used with liquids incompatible with the pump components, the liquid can
cause failure to the electrical insulation system resulting in electrical shock.
This equipment must not be handled or used by children. Children should not play with the
unit or within the immediate vicinity.
The pump has been evaluated for use with fresh water only.
Pumping sand or other abrasives can damage the pump and will void the warranty.
Do not pump heated liquids. Pump operating range is from 34°F to 120°F
Do not use in salt water or highly chlorinated water.
Failure to carry out routine maintenance or leaving the pump under reduced or no-flow
conditions for long periods (i.e., blocked pump filter) may result in accelerated wear.
Your pump motor is thermally protected. It is not recommended for pumping liquids over
120° F (49° C). The thermal overload protector will automatically shut down the pump in an
overheat situation. The pump will reset itself once the pump cools down. This overload is designed as a safety
device and it will fail after repeated use. Normal operation is for fluids between 34° F & 120° F.
All repairs must be made by an authorized service center.
The pump motor is hermetically sealed in the housing and does not require any service.
Disassembly of the motor housing or modification of the power cord will void the warranty.
To Next Page
Loading...
