1
SUBMERSIBLE POND PUMP
INSTALLATION & OPERATION MANUAL
Model Number
90084
Carefully read, understand and follow all safety instructions in this manual.
SAFETY GUIDELINES
SAFETY INFORMATION
This is the safety alert symbol. When you see this symbol, look for one of the following signal words.
Indicates a hazardous situation which, if not avoided, will result in death or serious injury.
Indicates a hazardous situation which, if not avoided, could result in death or serious injury.
Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
Indicates important information, that if not followed, may result in damage to the equipment.
RISK OF ELECTRICAL SHOCK. Disconnect and lockout power supply before removing
existing pump or installing or servicing this pump.
RISK OF ELECTRICAL SHOCK. This pump is supplied with a grounding conductor and
grounding type attachment plug. To reduce the risk of electric shock, be certain that it is
connected only to a properly grounded, grounding type receptacle. For added safety, it is highly recommended
to connect this pump to a GFCI (Ground Fault Circuit Interrupter) outlet. Connect only to a receptacle that is
adequately rated for the voltage and amperage of this pump.
The installation of this pump must be in accordance with the National Electric Code (NEC),
Uniform Plumbing Code (UPC), International Plumbing Code (IPC) as well as all applicable
local codes and ordinances.
Do not install this pump in any location classified as hazardous by the National Electrical
Code, ANSI/NFPA70.
Do not use this pump to pump flammable or explosive fluids such as gasoline, kerosene,
etc. Do not use this pump in flammable or explosive environments. Use only with liquids
compatible with pump component materials.
RISK OF ELECTRICAL SHOCK. This pump has not been investigated for use in swimming
pool or marine areas.
RISK OF ELECTRICAL SHOCK. DO NOT use the power cord to remove or lower the pump
into the water source. The cord may pull apart exposing bare wires which could cause a fire
or electrical shock. Grasp pump body for installing and removing the pump from water source.
Do not run the pump dry. This pump relies on water for cooling. Running the pump dry can
cause the pump to overheat and the possibility of burns to anyone that handles the pump.
Running the pump dry will void the warranty.
Read these warnings carefully. Know the application and limitations of this pump. Failure to follow these warnings
could result in serious bodily injury and/or property damage.
To Next Page
Need help?
General
