Supermicro 6038R-E1CR16H - Serverboard Details; X10 DRH-It Quick Reference

Chapter 5: Advanced Serverboard Setup
5-135-12
SUPERSTORAGESYSTEM 6038R-E1CR16H User's Manual
Figure 5-5. X10DRH-iT Layout
5-7 Serverboard Details
Notes
Jumpers not indicated are for test purposes only.
Note that the PCI slots are enabled when their corresponding processors are in-
stalled. "CPU2 Slot 4" indicates that a second CPU must be installed in the CPU2
socket to enable this PCI slot.
" " indicates the position of pin 1.
The LSI 3108 onboard controller chip in the layout image above is not populated
on the X10DRH-iT.
The 6038R-E1CR16H comes pre-installed with a Hardware RAID controller installed
in PCI-E slot 2 and a JBOD expansion port installed in PCI-E slot 1.
X10DRH-iT Quick Reference
Jumper Description Default Setting
JBT1 Clear CMOS/Reset BIOS Conguration See Section 5-9
JI
2
C1/JI
2
C2 SMB to PCI-E Slots Pins 2-3 (Disabled)
JPB1 BMC Enable/Disable Pins 1-2 (Enabled)
JPG1 VGA Enable/Disable Pins 1-2 (Enabled)
JPL1 TLAN1/TLAN2 Enable/Disable Pins 1-2 (Enabled)
JPME2 Manufacture (ME) Mode Select Pins 1-2 (Normal)
JWD1 Watch Dog Timer Pins 1-2 (Reset)
Connector Description
COM1/COM2 Backplane COM Port1/Front accessible COM2 header
FAN1-6,A, B Fan Headers
J24 24-pin ATX Main Power Connector
JD1 Speaker/Power LED Header
JF1 Front Control Panel Header
JIPMB1 4-pin External BMC I
2
C Header (for an IPMI card)
JL1 Chassis Intrusion Header
JPI
2
C1 Power Supply SMBbus I
2
C Header
JPWR1/JPWR2 12V 8-pin Power Connectors
JSTBY1 Standby Power Connector
JTPM1 TPM (Trusted Platform Module)/Port 80 Header
LAN1/LAN2 10G-bit Ethernet (TLAN) Ports
IPMI_LAN Dedicated IPMI LAN (supported by the ASpeed controller)
I-SATA 0-5 SATA 3.0 Ports (supported by Intel PCH)
S-SATA SATA 3.0 4-port Vertical Connector (supported by Intel SCU)
(I-)SGPIO1/2 Serial Link General Purpose I/O Headers
UID UID (Unit Identication) Button
USB 0/1 (2.0) USB 2.0 Ports (rear I/O)
USB 2/3 (2.0) USB 2.0 Headers
USB 4/5 (3.0) USB 3.0 Ports (rear I/O)
USB 7/8 (3.0) USB 3.0 Header
USB 6 (3.0) Type A USB 3.0 Connector
LED Description State Status
LE1 Rear UID LED Blue: On Unit Identied
LE2 Onboard PWR LED On Power On
LEDM1 BMC Heartbeat LED Green: Blinking BMC Normal
I-SATA5
I-SATA4
I-SATA0
I-SATA1
I-SATA2
I-SATA3
I-SGPIO1
I-SGPIO2
S-SATA
JS39
USB0/1
FAN6
FAN5
FANB
FANA
FAN3
FAN2
FAN1
JBT1
LEDM1
LE1
LEDS5
LEDS6
DS13
JIPMB1
SP1
J23
JPS7
JPG1
JBR1
JI2C2
JI2C1
JPME2
JPS1
JWD1
JTPM1
USB2/3
BIOS
BT1
JSTBY1
JL1
JOH1
JD1
JS1
JF1
JPWR2
JPWR1
JPI2C1
USB4/5
USB6
USB7/8
BIOS
LICENSE
MAC CODE
BAR CODE
(3.0)
(3.0)
(2.0)
TPM/PORT80
CPU1 SLOT1 PCI-E 3.0 X8
SAS4-7
COM2
CPU1 SLOT2 PCI-E 3.0 X8
CPU1 SLOT3 PCI-E 3.0 X8
CPU2 SLOT4 PCI-E 3.0 X16
CPU2 SLOT5 PCI-E 3.0 X8
CPU2 SLOT6 PCI-E 3.0 X8
UID
P1 DIMMC1 P1 DIMMC2
P2 DIMME1
P1 DIMMD1
P2 DIMME2
P1 DIMMD2
P2 DIMMF2 P2 DIMMF1
CPU1
P1 DIMMB2
P2 DIMMH2
P1 DIMMA2 P1 DIMMB1
P2 DIMMH1
P1 DIMMA1
P2 DIMMG2
VGA
P2 DIMMG1
LAN2
LAN1
(3.0)
IPMI_LAN
COM1
PWR I2C
CPU2 SLOT7 PCI-E 3.0 X8
FAN4
J24
X10DRH-C/i(T)
Rev. 1.00
JPB1JPL1
TFM
LE2
CPU2
SAS0-3
LSI 3108
SAS CTRL
PCH
BMC
CLOSE 1st
OPEN 1st
CLOSE 1st
OPEN 1st
Battery
LAN CTRL
JBOD ExpansionPort
AOC-S3008L-L8E